DX6e Manual

21SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL
EN
Telemetry Alarms
SelectInhunderAlarmtoselectthetypeofalarmdesired.Options
include Inh, Tone.
File Settings
This is used to select the data logging settings.
File Name
1. Select File Name to assign a custom file name.
2. The File Name screen appears, allowing you to name the file
as you would for a Model Name or Flight Mode Name. The file
namecanincludeamaximumof8characters.
3. Press BACK to save the name.
Start
1. Select Start to assign a specific switch position or stick
position that activates Data Logging.
2. Press the scroll wheel once to save the selection.
Enabled
WhenEnabledissettoNO,DataLoggingisturnedoff.
Select YES to save Telemetry data to the SD Card. The SD Card
must be installed in the transmitter to select YES.
CAUTION: If you access the Telemetry menu from the
Function List, you may see a Frame Loss appear when you
exitthemenu.TheFrameLossisnotanerror,buttherewillbea
momentarylossofradiosignalwhenexitingtheTelemetryscreen.
DO NOT access the Telemetry menu during flight.
Bind
The Bind menu enables you to bind a transmitter and receiver
without powering off the transmitter. This menu is helpful if you
are programming a model and need to bind the receiver for
failsafe positions.
See “Programming Failsafe Positions” for more information.
SYSTEM SETUP