DX6e Manual

42 SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL

PHYSICAL TRANSMITTER ADJUSTMENTS

Mode Change Slider

The DX6e has a unique Slider located on the back of the transmitter that allows for simple mode changes. The slider can also be used to change

each mode into a “quadcopter mode”. This mode snaps both stick to the center position.

Simply open the protective slider door and move the slider to the

desired position. All changes happen automatically inside the

transmitter.

If you are changing from mode 2(4) to mode 1(3) you must ﬁrst go into

the System Settings and change the mode in the programming.

Programming Conversion

1. Access the System Settings menu from the Setup List and

select the desired Mode.

2.ExittheSystemSettingsmenutosavetheselection.

Calibrating

After changing modes, the transmitter will need to be calibrated. See

the calibration section in System Settings.

Mode 2,4

Quadcopter

Mode 2,4

Quadcopter

Mode 1,3

Quadcopter

Mode Slider

Slider Door

Saftey plug

The Saftey plug is installed in the transmitter to ensure the mode

switch can not be accidentally moved when in the normal throttle

mode (non-centered) positions..

To remove the plug:

1. Grasp the plug by the raised rib and pull straight out.

Tip: A small screw driver can be used to gently pry the plug out.

2.Oncethemodehasbeenchanged,reinstallthesafteyplug.