DX6e Manual

32 SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
Telemetry
Telemetry is in both the system setup and the function list so you
can access the telemetry functions from either list.
You must power off the receiver and transmitter, then power them
bothontoresetthetelemetrydata.Youcanresetmin/maxvalues
by pressing the CLEAR button.
NEVER change Telemetry settings when the aircraft is powered
on.ThereisabriefinterruptioninRFoutputwhenexitingthe
Telemetry screen, and may cause a “Hold” condition.
System Setup
Use System Setup to enter the System List from the Function
list without turning the transmitter off. A Caution screen will
appear that warns that RF will be disabled (the transmitter will no
longer transmit). Press YES if you are sure and want to access
the System List. If you are not sure, press NOtoexittothemain
screen and continue operation.
If you do not press YES or NO,thesystemwillexittothemain
screenandcontinueoperationwithinapproximately10seconds.
WARNING: Do not press YES unless the model is turned
off or the model is secured.
Monitor
The Monitor screen displays the servo positions for each channel
graphically and numerically. This is useful to verify programming
functions,trimsettings,mixdirections,etc.Thenumericvalueis
directlyrelativetothetraveladjustandmixvalues(e.g.,100%
travel adjust equals 100% value in the Monitor).