DX6e Manual

25SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL

The Serial Number screen displays the transmitter serial number and AirWare software version.

Reference the Serial Number screen any time you need to register your transmitter or update the AirWare software from the Spektrum

Community website.

The transmitter Spektrum AirWare software version appears

between PREV and NEXT at the bottom of the Serial Number

screen. Register your DX6e to get Spektrum AirWare software

updates and other news at spektrumrc.com

IMPORTANT: Spektrum AirWare ﬁles are speciﬁc to the

transmitter serial number and you cannot transfer Spektrum

AirWare ﬁles between transmitters, ie., downloading an Spektrum

AirWare software update once and attempting to install it on

multiple transmitters.

CALIBRATE

Calibrating the Transmitter

1. Carefully move the gimbal sticks in a + shape moving from left

to right, then up and down. Press gently on the gimbals at the

stops to achieve an accurate calibration. Return both gimbal

sticks to the center position.

2. Select SAVE to store the calibration.

Serial Number

Exporting the Serial Number to the SD Card

Youmayndithelpfultoexportthetransmitterserialnumbertoa

textleforyourpersonalrecordsorwhenyouareregisteringthe

transmitter on the Spektrum Community.

To export the transmitter serial number:

1. Insert an SD Card in the card slot on the transmitter.

2. Scroll to EXPORT and press the scroll wheel. The SD Status

screenappearsandshoulddisplayMY_DX6e.xmlinthe

middle of the screen.

3. Press the scroll wheel again to return to the Serial Number

screen.

4. Power off the transmitter and remove the SD Card from the

transmitter.

5.InstalltheSDCardinacardreaderconnectedtoyour

computer.

6.OpentheMY_DX6e.xmllefromtheSDCardlocation.You

can then copy and paste the serial number into your personal

records or to the Spektrum Community website.

SYSTEM SETUP

Locating the Transmitter Spektrum AirWare Software Version

The Calibration screen stores the potentiometer endpoints for all proportional controls. It is mandatory to complete the calibration after

changing the stick mode selection.