Data Sheet

3. Move the throttle stick to the desired failsafe position, normally low throttle.

4. Follow the procedures of your speciﬁc transmitter to enter Bind Mode.

The system will connect within a few seconds. Once connected, the

LED on the receiver will turn solid, indicating the system is connected.

5. Remove the bind plug to prevent the system from entering bind mode

the next time the power is turned on.

6. After you’ve set up your model, rebind the system to reset the failsafe.

AR610 Failsafe

• Preventsunintentionalelectricmotorresponseonstart-up.

• Establisheslow-throttlefailsafeiftheRFsignalislost.

• Removesservooutputpulsestoallchannelsexceptthethrottlechannel

during failsafe.

• Failsafepositionisstoredviathethrottlestickpositiononthetransmitter

during binding.

HOW AR610 FAILSAFE WORKS

Receiver Power Only

• Whenthereceiveronlyisturnedon(notransmittersignalispresent),

the throttle channel has no output. This prevents arming of the

electronic speed control.

Shown using a separate receiver pack.

The battery can be connected to any open

port except the Bind port.

Once the bind process is complete, you can

remove the bind plug and connect the battery

to the Bind port.

Shown using an ESC/BEC and ﬂight pack.