Installation Guide

88051850 04/12
60 GALLON COMPRESSOR
CALIFORNIA PROPOSITION 65
WARNING: You can create dust
when you cut, sand, drill or grind
materials such as wood, paint,
metal, concrete, cement, or other
masonry. This dust often
contains chemicals known to
cause cancer, birth defects, or
other reproductive harm. Wear
protective gear.
WARNING: This product or its
power cord may contain
chemicals, including lead,
known to the State of California
to cause cancer and birth
defects or other reproductive
harm. Wash hands after
handling.
CAUTION:
FOR YOUR OWN SAFETY READ
INSTRUCTION MANUAL
COMPLETELY AND CAREFULLY
BEFORE OPERATING THIS
COMPRESSOR.
Failure to follow all instructions
as listed below may result in
electrical shock, fire, and/or
serious personal injury.
Breathable Air Warning:
This compressor/pump is not
equipped and should not be
used “as is” to supply
breathing quality air. For any
application of air for human
consumption, the air
compressor/pump will need
to be fitted with suitable in-
line safety and alarm
equipment. This additional
equipment is necessary to
properly filter and purify the
air to meet minimal
specifications for Grade D
breathing as described in
Compressed Gas Association
Commodity Specification G
7.1 - 1966, OSHA 29 CFR
1910. 134, and/or Canadian
Standards Associations
(CSA).
SPECIFICATIONS:
Tank Size: 60 gallons
CFM: 11.5 @ 40PSI;
10.2 @ 90 PSI
Horsepower (Running): 3HP
Max Pressure: 135 PSI
Thermal overload protection
INSTALLATION
Location
It is extremely important to
install the compressor in a
clean, well-ventilated area.
Make sure the temperature
will not exceed 100 degrees
Fahrenheit. A minimum
clearance of 12 to 18 inches
between the compressor fly
wheel or fan and walls is
required because objects
could obstruct the air flow.
Do not locate the compressor
air inlet near steam, paint
spray, sandblast areas or any
other source of
contamination.
Tank Mounting
The tank should be bolted on
a concrete floor or on a
separate concrete foundation.
Vibration isolators can be
used between the tank leg
and the floor. When using
isolator pads, do not draw
bolts tight. Allow the pads to
absorb vibrations. When
Model: 51850, 52332
[e-mail]