Owners manual

8
Important Operating Instructions
WARNING: Read the ENTIRE important operating instructions before set-up or use of this
product.
Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are
found, do not use the tool until it has been repaired.
WARNING: To prevent serious injury from accidental operation, turn off the tool, detach
the air supply, safely discharge any residual air pressure in the tool, and release the trigger
before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury, do not adjust or tamper with any control or component in a way
not specifically explained within this manual. Improper adjustment can result in tool failure
or other serious hazards.
Drill Bit Installation
Caution: Wear heavy-duty work gloves to provide protection when inserting and removing
drill bits. Drill bits become very hot during use.
Do not remove drill bits until the bit has cooled.
1. Loosen the chuck with the chuck key until the jaws of the drill are opened enough to fit
the drill bit.
2. Place the desired drill bit (not included) into the drill between the chuck jaws.
Note: In addition to single or double-ended screwdriver bits, adapters with hexagonal
shafts with matching socket heads can also be used.
3. Hand tighten the chuck until the bit is held securely in place, centered between the
chuck jaws.
4. Insert the tip of the chuck key into a hole on the side of the chuck so that the teeth on
the key engage the gear on the chuck. Use the key to tighten the chuck securely and
remove the key.
Notice: Use sharp bits. Dull, bent or damaged bits will cause stress on the drill
and/or break.
TOOL SET-UP