Installation Manual

11 SpeedTech Lights, Inc © 2019
RAPTOR
®
SUPER TD
VISOR LIGHT BAR
All rights reserved. No part of this Instruction Manual may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means,
including but not limited to photocopying, recording, electronic delivery, .PDF reproduction, or any other means of reproducing all or any part hereof without
the express prior written consent of SpeedTech Lights, Inc, except for non-commercial purposes as permitted by United States copyright law. Customers
of SpeedTech Lights, Inc, may download and print this Instruction Manual for use with products sold to the customer by SpeedTech Lights, Inc. However,
no part of this Instruction Manual may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by
any means, except with the prior written consent of SpeedTech Lights, Inc.
Flash Pattern List
Steady Burn
Steady Burn Left Side. Quad Flash Right Side 120 FPM
Steady Burn Right Side. Quad Flash Left Side 120 FPM
Double Flash Alternating 180 FPM
Double Flash Front/Back 210 FPM
Triple Flash 75 FPM
Double Flash Left/Right 210 FPM
Double Flash 2 In/2 Out
Double Flash Alternating
Quad Flash 60 FPM
Quad Flash 90 FPM
Single Flash Left/Right 210 FPM
Back to Front Sweep
Single Flash Alternating 120 FPM
Single Flash 75 FPM
Single Flash 60 FPM
Single Flash 150 FPM
Single Flash Alternating 300 FPM
Single Flash Alternating 270 FPM
Single Flash 180 FPM
Single Flash 90 FPM
Variable Speed Left/Right
Slow Back to Front Sweep
Variable Speed Alternating
Variable Speed
Left/Right Double Time
Clockwise/Counter Clockwise Sweep
Clockwise Sweep
Counter Clockwise Sweep
Fast Clockwise Sweep
Fast Counter Clockwise Sweep
Random
Flash Pattern Shortcuts
Hold ash pattern toggle/cable for 3 seconds to toggle Steady Burn mode.
Hold ash pattern toggle/cable for 5 seconds to toggle Random pattern mode.
About Flash Patterns
All STL LED products are equipped with a non-volatile memory which will recall the last ash pattern when the Light Bar is turned on.
Set the ash pattern by pushing the Flash Pattern button on the Grand Control Box to cycle through the various patterns.
If you are not using the Grand Control Box, follow the wiring diagram to identify the Flash Pattern wire to manually cycle through patterns.