Installation Manual

K-FORCE® 14” & 18”

How the Cigarette Lighter Plug Switch Operates Your STL Light Bar

Left On/O Switch:

• On Position: Turns on all the LED Modules in your light bar

• O Position: Turns o all the LED Modules in your light bar

Flash Pattern Button:

• Button cycles to the next ash pattern with each press. Non-Volatile memory recalls the last ash pattern selected.

• Hold ash pattern button down for 3 seconds to toggle Steady Burn mode.

• Hold ash pattern button down for 5 seconds to toggle Random pattern mode.

Wiring: Connecting Wires to the Battery

WARNING! If you are supplying your own wiring that connects to the positive or negative terminal of the battery, fuse sizes must be sized accord-

ing to STL’s provided fuse to be considered fused properly to the battery in order to carry the load.

• Route the power cables by opening the wiring shield and running the cables through it towards your vehicle’s rewall.

• Follow the factory wiring harness through the rewall.

• If it is necessary to drill a hole in the rewall for the power cables, be sure no components will be damaged from drilling. As with all holes

that are drilled, le the edges down smooth and insert a grommet to protect the cables.

• Route the cable along the factory wiring harness towards the battery.

• Wire your power cables (Red with In Line Fuse (STL Supplied) and Black cable) to your battery to power up your Light Bar.

• You will want to ensure your grounding cable is taken directly to the negative terminal of your battery to avoid any electrical feedback

which may disrupt your Light Bar system.

• DO NOT allow the positive (Red wire) and negative (Black wire) to touch one another. This may cause injury to you and damage your equip-

ment by causing a short in the unit that is not covered under the STL warranty.

Wiring: Connecting Wires to Control Box

• This unit will feature a power harness with three (3) colored leads with a connector that plugs into the Cig Plug. When not utilizing the Cig

Plug reference the Wiring Diagram above.

• Now that you have pulled the cable into the vehicle attach the connector back to your Light Bar’s wire harness in the CORRECT positions

using a pin pusher and plug it into your Cigarette Lighter Plug. If you do not know the correct position of each wire in the connector call

customer service at 800-757-2581 before proceeding.

• If you did not purchase the Cig Plug and are using your own switch box , wire the cables accordingly into your control panel by referencing

the wiring diagram and instruction manual of your control panel.