DOME ® BEACON Y-DMB12 Y-DMBM12 INSTRUCTION MANUAL 1 SpeedTech Lights, Inc © 2019
DOME ® BEACON Warnings and Notices for Users and Installers This document must be delivered to and read by the end user and installer as it serves to provide you with the required information for proper and safe use of your STL product. Before operating this or any STL products the user and installer must read this manual all the way through. You will find important information in this manual that could prevent property damage and/or serious injury to the user and installer.
DOME ® BEACON Important Points for Your Safety and Longevity of Your Light Bar • • • • • • • • • • • • • • • Installers are required to have a good understanding of automotive electronic systems and procedures for proper installation. Never stare directly into the LEDs as momentary blindness and/or eye damage may occur. Never take any lights through a car wash. Use only water to clean the outer body/lens of your equipment. Never use a pressure washer to clean any STL products.
DOME ® BEACON Wiring Diagram Wire Color Function Red* Positive Black* Negative Blue Flash Pattern Yellow Sync (Pattern Synchronization) * Indicates a main power cable. NOTE: Flash pattern cable contacts Negative cable. Specifications Voltage 12 VDC Amps <2 LED Count 12 Cable Length 1’ Flash Patterns 29 Cigarette Lighter Plug Switch Operation (Sold Separately) On/Off Switch: • On Position: Turns on the Beacon. • Off Position: Turns off the Beacon.
DOME ® BEACON Flash Pattern List • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Single Flash 75 FPM Phase 1 – Sync* Single Flash 75 FPM Phase 2 – Sync* Single Flash Rotator 75 FPM Single Flash Rotator 100 FPM Single Flash 120 FPM Phase 1 – Sync* Single Flash 120 FPM Phase 2 –Sync* Single Flash Rotator 120 FPM Single Flash Rotator 150 FPM Single Flash 375 FPM Phase 1 – Sync* Single Flash 375 FPM Phase 2 – Sync* Single Flash Rotator 375 FPM Double Flash 75 FPM Phase 1 – Sync* Double Flash 75 FP
