Installation Manual
ROAD FLARE
SpeedTech Lights, Inc © 2018
Charging
1. Place 1-6 ares into the pockets in the charging case with the magnet facing down and lining up the silver charging guide inputs over the
outputs. Charge time for 1-3 ares is 2-6 hours. Charge time for all 6 ares is 12-14 hours. Will store full charge for 90 days.
2. Depending on your application, plug male end of the wall charger or the car charger into the power input port in the charging case.
3. Plug the wall or car charger in.
Red Light on Power Adapter: Successfully plugged in to power
Green/Yellow Light on Charge Case: Charge in progress. Light will go from Green to Yellow during charging
Red Light on Charge Case: Fully charged
All rights reserved. No part of this Operations Manual and Instructions may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means, including but not limited to photocopying, re-
cording, electronic delivery, .pdf reproduction, or any other means of reproducing all or any part hereof without the express prior written consent of the SpeedTech Lights, Inc., except for non-commercial purposes as
permitted by United States copyright law. Customers of SpeedTech Lights, Inc., may download and print this Operations Manual and Instructions for use with products sold to the customer by SpeedTech Lights, Inc.
However, no part of the Operations Manual and Instructions may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by any means, except with the prior
written consent of SpeedTech Lights, Inc.
1. Rotate (7 hour run time) 8. SOS Rescue (Morse Code) (12 hour run time)
2. Quad Flash
(7 hour run time)
9. Steady Burn High
(4 hour run time)
3. Quad Alternating Flash
(7 hour run time)
10. Steady Burn Low
(30 hour run time)
4. 1.3.5.7 LED Flash
(12 hour run time) 11. 2 LED Flashlight (7 hour run time)
5. 2.4.6.8 LED Flash
(12 hour run time)
12. 4 LED Flashlight
(5 hour run time)
6. Single Blink
(50 hour run time)
13. O
7. Alternating Blinks
(7 hour run time)
Operation
Press the On/O button to power On.
Press and hold On/O button down for 2 seconds to power O.
Press the On/O button on each are to rotate through the below 12 patterns: