Installation Manual

ROAD FLARE

All STL equipment needs to be mounted and installed according to the vehicle manufacturer’s instructions and securely attached to a part of the

vehicle of sucient strength to withstand the forces applied by the equipment. This device should be permanently mounted within the zones

specied by the vehicle manufacturer. This especially applies to equipment mounted on the exterior of the vehicle to avoid dislodging. Mount-

ing units on the interior of the vehicle by a method other than permanent mount is discouraged as it may become detached under aggressive

driving conditions such as sudden braking, collision, or swerving.

PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMERGENCY

WARNING DEVICES IS ESSENTIAL TO ENSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE PUBLIC.

Unpacking Your STL Product

• Unpack your unit to identify all parts including but not limited to: switch box, brackets, screws, bolts, wiring harness, fuses, etc.

• Some parts may be in small bags.

• Some products may be packaged inside boxes of other products.

• Some parts such as Gutter Brackets, may be in the foam protection. Double check that no parts are left within the foam protection or left

in the box.

Pre-Installation and Testing

BENCH TEST all units prior to installation by connecting the Positive Cable (Red) and Negative Cable (Black) to a power source to ensure all the

features and parts of the Switch Box are functional.

If you have trouble call Customer Service at 800-757-2581 before proceeding.