Installation Manual

RAPTOR®-X SERIES
SpeedTech Lights, Inc © 2018
Next take Qty. 1 - Phillips pan head screws and Qty. 1 - Flat washers, placing the washer on the screw and inserting through the opening
On the other end insert Qty. 1 – Flat washer followed by Qty. 1 – Split Lock washer and nally placing Qty. 1 – Hex nut to secure.
NOTE: Do not tighten at this point as adjusting will need to be done.
• Repeat the same steps 3 more times for each assembly, should come out to a total of 4 assemblies all together. Each assembly should look
like this: