Installation Manual

RAPTOR®-X SERIES

Installing Raptor Brackets

1. Inspect contents of package, included in each kit should be a bag of hardware, rubber protective strips, spacers and brackets.

• Hardware contents (Q-307 -Universal brackets only)

Qty. 20 – Philips pan head screws

Qty. 30 – Flat washers

Qty. 20 – Split Lock washers

Qty. 12 – Hex nuts

Qty. 2 – Rubber protective strips

Qty. 1 – Bag of spacers (5.14MM) (For spacer installation go to Spacer Installation)

Qty. 1 – Bag of spacers (10MM) (For spacer installation go to Spacer Installation)

• Brackets

Qty. 4 – Base bracket

Qty. 4 – Forked visor bracket (Will not use if vehicle specic brackets are purchased

• If vehicle specic brackets are ordered the hardware contents will include. For installation of vehicle specic brackets go to Vehicle Specic

Bracket Installation

Qty. 8 – Allan screws (Black)

Qty. 8 – Hex Lock nuts

Bracket Assembly

2. After inspecting content of package, start by assembling the “Base bracket” and “Forked visor bracket” together.

• Take attach the “Base bracket” and “Forked visor bracket” you will need the following:

Qty. 2 – Phillips pan head screws

Qty. 4 – Flat washers

Qty. 2 – Split Lock washers

Qty. 2 – Hex nuts

• Take the both brackets and place them against each other, ensuring that the fork bracket is pointing up