Installation Manual

RAPTOR® SERIES

Mounting Headliner Bracket:

• There will be four (4) pieces per side. Two (2) forked pieces and two (2) rectangular pieces.

• Mount the forked pieces to the back of the bar with the forked pieces pointed away from the LEDs.

• Mount the rectangular piece to the back of the bar lining it up with one of the two mounting locations that will provide the best t.

How the STL Grand Control® Box Operates Your Raptor® Series

Power:

• Press to power on ashing mode

• Press again to shut o ashing mode

Flash Pattern:

• Cycles to the next ash pattern with each press. Non-Volatile memory recalls the last ash pattern selected.

• Hold ash pattern button down for 3 seconds to toggle Steady Burn mode.

• Hold ash pattern button down for 5 seconds to toggle Random pattern mode.

RAPTOR SPECIFIC CONTROLS

*TD:

• 1st Press: Steady Burn

• 2nd Press: Pulsing Flash

• 3rd Press: Flash in the same sequence/ash pattern as the light bar when the warning lights are activated

*Aux (Red ((+) Positive) and Blue ((-) Negative) wires):

• Rated for 10 AMPs

• 1st press: Power ON unit attached to aux cables

• 2nd press: Power OFF unit attached to aux cables

RAPTOR SUPER TAKE DOWN SPECIFIC CONTROLS

*TD:

• 1st Press: Steady Burn

• 2nd Press: Pulsing Flash

• 3rd Press: Flash in the same sequence/ash pattern as the light bar when the warning lights are activated

*Super TD:

• 1st press: Entire unit Steady Burn

• 2nd press: Entire unit Pulsing Flash

• 3rd press: Super TD o.

*These functions can be operated independently of the light bar’s warning lights being activated

Wiring: Connecting Wires to the Battery

WARNING! If you are supplying your own wiring that connects to the positive or negative terminal of the battery, fuse sizes must be sized according

to STL’s provided fuse to be considered fused properly to the battery in order to carry the load.

• Route the power cables by opening the wiring shield and running the cables through it towards your vehicle’s rewall.

• Follow the factory wiring harness through the rewall.

• If it is necessary to drill a hole in the rewall for the power cables, be sure no components will be damaged from drilling. As with all holes

that are drilled, le the edges down smooth and insert a grommet to protect the cables.

• Route the cable along the factory wiring harness towards the battery.

• Wire your power cables (Red with In Line Fuse (STL Supplied) and Black cable) to your battery to power up your Light Bar.

• You will want to ensure your grounding cable is taken directly to the negative terminal of your battery to avoid any electrical feedback which

may disrupt your Light Bar system.

• DO NOT allow the positive (Red wire) and negative (Black wire) to touch one another. This may cause injury to you and damage your equip-

ment by causing a short in the unit that is not covered under the STL warranty.