Installation Manual
4 SpeedTech Lights, Inc © 2019
OCTO
®
BEACON
Magnet Mounts (Included)
• This unit comes included with magnetic mounting brackets pre-attached.
• Ensure all magnets are secured to a at surface.
Cigarette Lighter Plug Switch Operation (Sold Separately)
On/O Switch:
• On Position: Turns on the Beacon.
• O Position: Turns o the Beacon.
Flash Pattern Button:
• Button cycles to the next ash pattern with each press.
• Non-Volatile memory recalls the last ash pattern selected.
• Hold ash pattern toggle for 3 seconds to toggle Steady Burn mode.
• Hold ash pattern toggle for 5 seconds to toggle Random pattern mode.
Extension Cable (Sold Separately)
• If you have an extension cable with connectors, connect the corresponding ends to one
another. Use the connector at the end of the cable to plug into the control box.
• If you have an extension cable with one connector, you will need to cut the connector
o of the main cable harness coming out of the Beacon. Save it as a spare part. You will
solder, and heat shrink each wire within the cable harness to each wire in the extension
cable harness. DO NOT cross connect wires. Use the connector at the end of the
extension cable to plug into the control box.
• If you have an extension cable with no connectors, you will need to cut in the middle of
the main cable harness coming out of the Beacon. You will solder, and heat shrink each
wire within the cable harness to each wire in the extension cable harness. DO NOT
cross connect wires. Use the connector at the end of the main cable harness to plug
into the control box. DO NOT leave connectors, cables, solder points exposed to heat,
moisture, or debris.
Wiring Diagram
Wire Color Function
Red*
Positive
Black*
Negative
Yellow
Flash Pattern
* Indicates a main power cable. NOTE: All cables except Negative contact +12 VDC.
Specications
Voltage
12 VDC
Amps < 2.8
Optic TIR
LED Count 24
Cable Length 9.5’
Flash Patterns 32