Installation Manual

ManualsBrandsSpeedTech Lights ManualsAutomotiveSpeedTech Lights Mini 21" 120 Watts LED Strobe Lights for Trucks, Cars, Plows, and Emergency Vehicles with Magnetic Roof Mount in Amber/White (Amber/Clear)

K-FORCE

MICRO 21

MINI LIGHT BAR

Grand Control Switch Box Operation (Sold Separately)

Power Button:

• Toggle to power the Light Bar On and O.

Flash Pattern Button:

• Toggle button to cycle to the next ash pattern with each press.

• Non-Volatile memory recalls the last ash pattern selected.

• Hold ash pattern toggle for 3 seconds to toggle Steady Burn mode.

• Hold ash pattern toggle for 5 seconds to toggle Random pattern mode.

TD Button*:

• 1st press: Steady Burn Alley.

• 2nd press: Flashing Alley.

• 3rd press: Flash Alley in the same sequence/ash as the active warning pattern.

AUX Button*:

• Toggle button to power AUX cables On and O.

Back Plate Mount:

• Included with Grand Control Switch Box purchase.

* Warning lights do not need to be activated for these Buttons to be functional.

Extension Cable (Sold Separately)

• If you have an extension cable with connectors, connect the corresponding ends to one another.

Use the connector at the end of the cable to plug into your control box.

• If you have an extension cable with one connector, you will need to cut the connector o of the main

cable harness coming out of the Light Bar. Save it as a spare part. You will solder, and heat shrink

each wire within the cable harness to each wire in the extension cable harness. DO NOT cross

connect wires. Use the connector at the end of the extension cable to plug into your control box.

• If you have an extension cable with no connectors, you will need to cut in the middle of the main

cable harness coming out of the Light Bar. You will solder, and heat shrink each wire within the

cable harness to each wire in the extension cable harness. DO NOT cross connect wires. Use

the connector at the end of the main cable harness to plug into your control box. DO NOT leave

connectors, cables, solder points exposed to heat, moisture, or debris.

Wiring Diagram

Wire Color Function

Red*

Positive

Black*

Negative

Yellow

Flash Pattern

* Indicates a main power cable.

Wire Color Function

White

Positive (When bypassing Grand Control Box)

Blue

Alley Steady

Green

Take Down Flashing

NOTE: All cables except Negative contact +12 VDC.

Specications

Voltage

12 VDC

Amps < 5.8

Optic TIR / Linear

LED Count TIR: 40 / Linear: 60

Cable Length 13’ Light Bar Cable, 1.8’ CLP Cable, 8’ AUX Cable

Flash Patterns 30

AUX Wiring Diagram

Wire Color Function

Red

AUX Positive

Blue

AUX Negative