Installation Manual

FLARE® SERIES

How to Alternate Sync the Flare® Series Together

• Divide the Flare® products into two Groups.

• Take all the Red cables from Group 1 and tie them together.

• Take all the Black cables from Group 1 and tie them together.

• Take all the Yellow cables from Group 1 and tie them together.

• Take all the White cables from Group 1 and tie them together.

• Take all the Blue cables from Group 1 and tie them together.

• Connect the Red cables to Power.

• Connect the Black cables to Ground.

• Group 1 is ready for syncing.

• Follow all same procedures for Group 2 as with Group 1.

• Now that both Groups are ready for syncing, take all the Blue cables from Group 1 and hold them to +12VDC for 3 seconds. Half of all units

in Group 1 will light up steady burn.

• Quickly take all the Blue cables from Group 2 and hold them to +12VDC for 5 seconds. You will notice half of all units in Group 2 will light up

steady burn after 3 seconds. Continue to hold it for a total of 5 seconds and you will notice the opposite half of the units will light up steady

burn.

• Once you have programmed both Groups such that Group 1 and Group 2 are all steady burn on opposite sides of each other, disconnect

+12VDC and quickly reconnect +12VDC. NOTE: This step must be done quickly. If any of the Groups go o steady burn and no longer

light up, this step must be repeated. Group 1 and Group 2 units must be half steady burn when you disconnect +12VDC or else

proramming will be incomplete.

• Programming is complete and Group 1 will Single Flash alternatively with Group 2.

Wiring: Connecting Wires to the Battery

WARNING! If you are supplying your own wiring that connects to the positive or negative terminal of the battery, fuse sizes must be sized accord-

ing to STL’s provided fuse to be considered fused properly to the battery in order to carry the load.

• Route the power cables by opening the wiring shield and running the cables through it towards your vehicle’s rewall.

• Follow the factory wiring harness through the rewall.

• If it is necessary to drill a hole in the rewall for the power cables, be sure no components will be damaged from drilling. As with all holes

that are drilled, le the edges down smooth and insert a grommet to protect the cables.

• Route the cable along the factory wiring harness towards the battery.

• Wire your power cables (Red and Black cable) to your battery to power up your Light.

• You will want to ensure your grounding cable is taken directly to the negative terminal of your battery to avoid any electrical feedback

which may disrupt your Light system.

• DO NOT allow the positive (Red wire) and negative (Black wire) to touch one another. This may cause injury to you and damage your equip-

ment by causing a short in the unit that is not covered under the STL warranty.

Mounting Flare Flange Bracket:

• Push the Flare model into the Flange up through the rear.

• Use the included hardware to mount the Flange to vehicle.