Installation Manual

ManualsBrandsSpeedTech Lights ManualsAutomotiveFlare-X LED Steady Burn Surface Mount - Clear

FLARE® SERIES

Wiring: Connecting Wires to Control Box

• This unit will feature a power harness with six (6) colored leads. Reference the Wiring Diagram above.

• If you are using your own switch box, wire the cables accordingly into your control panel by referencing the wiring diagram and instruction

manual of your control panel.

Wiring: Connecting Extension Cables

• This unit will feature a power harness with six (6) colored leads.

• If you have an extension cable with connectors, connect the corresponding ends to one another. Use the connector at the end of the cable

to plug into your control box.

• If you have an extension cable with one connector, you will need to cut the connector o of the main cable harness coming out of the Light.

Save it as a spare part. You will solder, and heat shrink each wire within the cable harness to each wire in the extension cable harness. DO

NOT cross connect wires. Use the connector at the end of the extension cable to plug into your control box.

• If you have an extension cable with no connectors, you will need to add the desired length to the end of the cable coming out of the Light.

You will solder, and heat shrink each wire within the cable harness to each wire in the extension cable harness. DO NOT cross connect

wires. Use the connector at the end of the main cable harness to plug into your control box. DO NOT leave connectors, cables, solder points

exposed to heat or moisture or debris.

Programming Flash Patterns

• All STL LED products are equipped with a non-volatile memory which will recall the last ash pattern when the light is turned on.

• Set your ash pattern by tapping the Flash Pattern cable to +12VDC

Maintenance

While STL’s Lights are very durable, there are some things you need to keep in mind and practice to preserve the longevity and function of your

light.

• Never take any STL Lights through a car wash, such as a pressure washer, automatic car wash, brushes that will scratch your equipment or

similar car washes or equipment where chemicals, high pressure water, and materials may scratch or damage your equipment.

• Use Water (H2O) with a soft cloth to clean your Light and lenses.

• Yellowing of clear lenses may occur overtime. Lenses can be purchased by calling STL Customer Service at 800-757-3581.

All rights reserved. No part of this Operations Manual and Instructions may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means, including but not limited to photocopying, recording,

electronic delivery, .pdf reproduction, or any other means of reproducing all or any part hereof without the express prior written consent of the SpeedTech Lights, Inc., except for non-commercial purposes as permitted

by United States copyright law. Customers of SpeedTech Lights, Inc., may download and print this Operations Manual and Instructions for use with products sold to the customer by SpeedTech Lights, Inc. However, no

part of the Operations Manual and Instructions may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by any means, except with the prior written consent

of SpeedTech Lights, Inc.