Installation Guide

Task 3: Ceiling & Wall Application
A Rotozip sprial saw, key hole saw or utility knife is used to cut the drywall
at the marked location for the Speedi-Boot installation. Tip: Have a vacuum
or box to catch the dust and or debris during cutting. Also there may be attic
Insulation above the hole cut for the Speedi-Boot installation, (See Figure).
Task 4: Speedi-Boot Installation
Access the attic location with your Speedi-Boot, insert the Speedi-Boot into
the Hole so that the gasket on the Speedi-Boot frame is flush with the
unfinished side of the drywall, extend the telescoping hanger arms to
interface with the truss, rafters placing the foot of the hanger arm flush with
the top of the unfinished side of the drywall then nail and or screw into