User Guide

CoilShot

Operating and Maintenance Manual

Operating Instructions

Pre-Operation Checklist

• Check spray nozzles and make sure orifice is not blocked or worn to excess.

• Check water hose for leaks or kinks.

• Check all connections, fittings, screws and fasteners.

• Check that there are enough tablets to completely clean all coils.

Normal Coil Cleaning Operation

CAUTION: Turn off electrical power to unit being cleaned and wear appropriate P.P.E.

(Review the CoilShot and CoilShot-HD SDS before usage)

1. Connect a standard garden hose to the connection at the base of the gun. Note: Water

Pressure must be less than 70 psi and less than 100

2. Install the nozzle at the tip of the gun, turn on the water source, squeeze the trigger and

pre-rinse the coil to be cleaned. Confirm that all of the connections are tight and that

there are no leaks.

3. Turn the water source off.

4. Insert the CoilShot

or CoilShot

-HD cleaning tablet into the back of the gun.

5. Make sure that the latch secures the door. Note: If using a new tablet from a sealed bag,

make sure to reseal the bag to ensure no moisture gets to unused tablets.

6. Adjust mixing valve to desired amount of chemical to be applied (see chart below).

7. Turn the water source back on. Confirm that all of the connections are still tight and that

there are no leaks.

8. Squeeze the trigger and spray the coil.

9. Turn off the water supply.

10. Allow chemical to dwell on the coil for 3-5 minutes.

11. Turn the water supply on.

12. Use tablet completely before rinsing.

13. Rinse the coil until the cleaner is removed.

14. Turn the water supply off and squeeze the trigger to release the pressure.

Insert tablet

Attach hose

Clean coils