SpeedClean ® Innovative Maintenance Tools. CONDENSER NEEDLE ® Coil Cleaner OPERATING & MAINTENANCE INSTRUCTIONS U.S.
Thank you for purchasing this SpeedClean Condenser Needle® Coil Cleaner. We ™ appreciate your Needle business and look forward to serving you in the future. As with all Condenser SpeedClean products, you can be assured that the finest quality components and workmanship have gone into this machine. Please take a few minutes to read the following Operating and Maintenance Instructions. Please pay particular attention to the safety instructions and exercise caution when using this product.
Condenser Needle® General Safety Rules Save these Instructions!! 1. Work Area • Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents. • Keep bystanders, children, and visitors away while operating a tool. Distractions can cause you to lose control. 2. Personal Safety • Do not spray on electrical items — Possible electrocution or damage. • Stay alert, watch what you are doing and use common sense when operating.
Condenser Needle® Safety Checklist Do’s • • • Keep this manual with the unit at all times. Always run clean water through the unit after using the chemical injection system. Always relieve pressure in the spray gun and hose after use, and prior to transporting or storing. • • • • Always secure the unit while transporting to prevent it from damage. Always be extra careful when not on level, secure ground. Keep operational area clear of all persons. Use only SPEEDCLEAN recommended attachments.
Assembly Connect wand to spray gun and insert siphon tube into chemical container. Normal Usage 1. The Condenser Needle® is equipped with a chemical injection system, variable at a ratio of approximately 0 (no chemical) through 16 to 1. It will inject chemical from a separate chemical container. 2. Insert Condenser Needle® into coil and clean from the inside to outside blowing the debris in reverse direction from the operational flow. 3.
Troubleshooting Condenser Needle™ ISSUE PROBABLE CAUSE REMEDY No water when spray gun trigger is squeezed • Water is not turned on • Turn water on • Hoses and/or nozzle clogged • Check hoses and nozzles for clogs Low water pressure or flow • Restricted valves, nozzle or hoses • Open all valves completely; check hoses and nozzles for debris. • Low input flow or pressure • Check for other valves that are not completely open.
Parts List Condenser Needle® 2. 8918 Sleeve 3. 9650-2 Clamp 4. QDN-MAP Male Quick Connect 5. 6032 ¼ Hose Barb 2 3 5 4 6. 7060-1 Braided Hose 15” long 7. 8919 Clamp 8. QDN-FA2 Female Connector 9. 917 Nipple 6 7 10. Check Valve Assembly completed this end 11. 8915 Flow Control 8 12. 8932 Clear Hose 8 Feet Long 9 14 13. 8914-1 Spring Strainer 15 14. 8943-4 ¼ to ¾ FGH Connector 10 15. 1543 Washer 16 11 16. 8914 Siphon 17 17. (2)1543 Washers 18. 8966 Spray Gun 12 18 19.
PO Box 110301 Stamford, CT 06911-0301 (888) 700-3540 www.speedclean.com SpeedyFoam® CoilJet ® Mini-Split Bib® Kit SpeedClean is a registered trademark of Crossford International. SpeedClean reserves the right to improve products; contact the factory for the latest configuration and uses.
