Installation Instructions

NOTE: To avoid long run-down time (45 minutes fac-

tory default) when testing operation, refer to Test

Setting section.

Installing Coin Slide Assembly Into Meter Case:

Option Two

1. Install coin slide according to manufacturer’s instructions.

2. Insert coins into coin slide and slowly push slide in. Stop be-

fore coins fall into coin box. This will allow installing exten-

sion through meter case service door opening.

3. Install slide extension onto top of coin slide using two screws.

Refer to Figure 38 .

4. Check to make sure coin slide is operating properly by insert-

ing coins and starting a cycle. The IN USE light will turn on,

or flash if it is already on, to indicate proper operation.

NOTE: To avoid long run-down time (45 minutes fac-

tory default) when testing operation, refer to Test

Setting section.

ending

DO NOT COPY or TRANSMIT

Part No. D516906ENR1