Installation Instructions

TLW1610K_SVG

1. Shoulder Bolt

2. Spring

3. Flat Washer

4. Rounded Corner

5. Nut

6. Extension Lever

7. Extension Bracket

Figure 36

5. Install extension bracket and lever assembly onto coin slide

bracket using two screws and locknuts. Refer to Figure 37 .

IMPORTANT: Install coin slide bracket with side

marked “A” facing up and toward extension bracket

and lever assembly. Refer to Figure 37 .

TLW2163N_SVG

1. Spring Installed

2. Extension Bracket and Lever Assembly

3. Coin Slide Bracket - Letter "A"

Figure 37

6. Install coin slide extension assembly onto top of coin slide us-

ing two remaining screws and lockwashers. Place lockwasher

under head of screws, above bracket “A”. Refer to Figure 38 .

TLW2164N_SVG

1. Coin Slide Extension Assembly

2. Spring Installed

Figure 38

7. Before installing coin slide and extension, make sure ground

wire is tucked under control shield to provide clearance for

coin slide. Refer to Figure 39 .

TLW2157N_SVG

1. Ground Wire Placement

Figure 39

Installing Coin Slide Assembly Into Meter Case:

Option One

1. Insert coins and partially extend coin slide.

2. Insert coin slide on its side through meter case opening. Then

rotate 90 degrees to its proper orientation.

3. Return coin slide and hook slide pins onto meter case.

4. Continue coin slide installation according to manufacturer’s

instructions.

5. Check to make sure coin slide is operating properly by insert-

ing coins and starting a cycle. The IN USE light will turn on,

or flash if it is already on, to indicate proper operation.

Vending

DO NOT COPY or TRANSMIT

Part No. D516906ENR1