Installation Instructions

Heat Switch Number

Heat Time

Per Coin

Pulse (in mi-

nutes) 1 2 3 4 5 6

57 OFF OFF OFF ON ON ON

58 ON OFF OFF ON ON ON

59 OFF ON OFF ON ON ON

60 ON ON OFF ON ON ON

61 OFF OFF ON ON ON ON

62 ON OFF ON ON ON ON

63 OFF ON ON ON ON ON

64 ON ON ON ON ON ON

Table 9

Test Setting

When testing coin slide operation or other troubleshooting, set

dipswitch with this shorter cycle:

1. Unplug the machine power cord.

2. Record the machine control dipswitch settings. Then set them

all to the off position. Refer to Figure 1.

3. Plug in the machine and initiate a cycle.

NOTE: With all the control dipswitches off, the total

cycle time will be four minutes long.

4. Once all the testing is complete, unplug the machine and re-

set the dipswitches to their original settings.

Plug in the machine.

Slide Extension Assembly

1. Remove slide extension parts from parts accessories bag in-

cluded in unit.

2. Install extension lever with arm that has one star facing down.

Refer to Figure 35 .

TLW2160N_SVG

1. One Star

Figure 35

3. Install extension lever with rounded corner facing away from

extension bracket using shoulder bolt, flat washer and nut.

Refer to Figure 36 .

4. Install spring to extension bracket with hook facing down. In-

stall other end of spring to extension lever with hook facing

left while standing in front of unit. Refer to Figure 36 .

Vending

DO NOT COPY or TRANSMIT

Part No. D516906ENR1