Installation Instructions

NOTE: The control reads the dipswitch settings at pow-
er-up. The control must be powered down to change
the dipswitch settings.
NOTE: The control must be powered down for 10 sec-
onds before the dipswitch can be changed.
Dipswitch1 Bank
Refer to Table 7 .
Dipswitch1 Bank
Switch OFF ON
1 120 VAC supply 240 VAC supply
2 Unused Unused
3 Unused Unused
4 Unused Unused
5 Unused Unused
6 Unused Unused
7 Unused Unused
8 Unused Unused
Table 7
Dipswitch2 Bank
In Dipswitch2 bank, dipswitches 1 - 6 can be used to add addi-
tional dry time per coin pulse. This extends the total Dry Time
Per Vend amount. For each of these switches that are ON, time is
added in minutes. The maximum cycle length is 99 minutes. Heat
and cooldown time combined can never be longer than 99 mi-
nutes. Refer to Table 8 .
Dipswitch 7 specifies Cool-Down time for vended machines. The
Cool-Down time is three minutes when this switch is OFF, and
ten minutes when the switch is ON. For non-vended machines,
Cool-Down time is determined by the position of the Tempera-
ture Selector Switch.
Dipswitch 8 is used for the cycle reset on vended machines. If the
switch is OFF (default), the control will save the time left on a
cycle in case of a power failure. If the switch is ON, the control
will clear the cycle and return to Ready Mode if there is a power
failure. On non-vended machines, the control will clear any cycle
time and reset to Start Mode, regardless of the positions of these
dipswitches.
Dipswitch2 Bank
Switch OFF ON
1 Dry time per vend
[1]
Plus 1 minute dry
time per vend
2 Dry time per vend
[2]
Plus 2 minute dry
time per vend
3 Dry time per vend
[3]
Plus 4 minute dry
time per vend
4 Dry time per vend
[4]
Plus 8 minute dry
time per vend
5 Dry time per vend
[5]
Plus 16 minute dry
time per vend
6 Dry time per vend
[6]
Plus 32 minute dry
time per vend
7 Short Cool-Down
time
Long Cool-Down
time
8 Save cycle time on
long powerfail
Clear cycle time on
long powerfail
Table 8
Resetting Cycle Time to Zero
To remove any cycle time that may have accumulated on the con-
trol during setup, the cycle time on the control can be reset to
zero.
To reset the time, unplug the dryer and set dipswitch 8 to ON po-
sition. Restore power to the dryer for 10 seconds and once again
unplug dryer. Set dipswitch 8 to OFF position and restore power
to the dryer.
Vending
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
33
Part No. D516906ENR1