Installation instructions

a. Insert the end of the beaded strap into the larger hole

found on the end of the strap.

b. Tighten to desired fit.

c. Lock strap in place by pulling beaded strap into the tam-

pered smaller opening of the beaded strap end. A distinct

snap noise should be heard once the strap is properly seat-

ed.

d. Pull on the strap once locked in place to ensure beaded

strap is properly installed. This will prevent the drain hose

from dislodging from drain receptacle during use.

SWD1010N_SVG

1. 24 to 36 in. [610 to 914 mm] Recommended Height

2. Beaded strap from accessory bag

3. Standpipe 2 in. [51 mm] or 1-1/2 in. [40 mm]

Figure 8

Wall Installation

For installations of this type, the drain hose MUST be secured to

one of the fill hoses using the beaded strap from accessories bag.

Refer to Figure 9 .

NOTE: End of drain hose must not be below 24 in. [610

mm].

H023i_SVG

Drain Hose

2. Beaded Strap (tape if necessary)

3. Fill Hoses

Figure 9

Laundry Tub Installation

For this type of installation, the drain hose MUST be secured to

the stationary tub to prevent hose from disloding during use. Re-

fer to Figure 10 . Use the beaded strap (supplied in accessories

bag) to secure hose.

SWD1011N_SVG

1. Drain Hose

2. Beaded Strap (tape if necessary)

Figure 10

Installation

DO NOT COPY or TRANSMIT

13 Part No. 804671ENR4