Use and Care Guide

Washer Symptom Possible Cause/Solution
Er, FL on digital display
• This code will appear if the washer has not reached the fill level after 30 minutes during a
wash or rinse fill.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Clean the screens in the water mixing valve and the filter screens located at the faucet
end of the fill hoses.
• Unplug the machine for 15 seconds to clear this code.
OF, St on digital display
• This code indicates the washtub has filled to the overflow level.
• After pressing Start/Pause buon the machine will begin to spin to aempt to pump
water out.
•
If Start/Pause buon is not pressed within five minutes, Er, OF will be displayed and the
machine will need to be unplugged for 15 seconds to clear the code.
Er, dr on digital display
• This code indicates that water is still in the washer at the end of the cycle.
• Check the drain hose and drain receptacle to make sure they are installed properly and
not blocked.
• Unplug the machine for 15 seconds to clear this code.
Er, PS on digital display
• The control has detected trouble sensing the water fill level.
• Unplug the machine and call for service.
Other Er Codes
•
If the control displays any other Er codes, unplug the machine for 15 seconds. Plug the
machine back in. If code still appears, call for service.
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
19 Part No. 204402EN