Manual

-12-
802759
To Change Cycles
If the selected cycle is not the correct cycle for
the fabric being washed, you may change the cycle
selection at any time until the first wash fill is
complete. Once the washer has filled for the first
part of the cycle (the wash portion), the current
cycle must be aborted and a new cycle must be
started.
To change the cycle before the first fill is
complete:
Change the cycle selected on the cycle selector
knob.
To change the cycle after the first fill is
complete and before the first wash is complete:
1. Abort the current cycle by changing the
cycle selector knob to the OFF position.
2. Set the WASH/RINSE temperature selector.
3. Set cycle selector knob.
4. Turn on extra rinse, if desired.
5. Press and hold the START button for two
seconds.
To change the cycle after the first wash is
complete:
NOTE: This should only be done if the speed of
the final extract is incorrect for the fabric being
washed. For example, if washing delicate items
on the REGULAR cycle, the high speed extract
may damage the fabric. Or, if washing towels or
jeans on the DELICATE cycle, the lower speed
extract would increase drying time.
1. Abort the current cycle by changing the
cycle selector switch to the OFF position.
2. Restart the cycle from the beginning. Refer
to the To Wash Clothes section.
To Pump Out Water After Aborting Cycle
Run a SPIN ONLY cycle. This cycle will perform a
high speed extract operation that will pump all of
the water out of the washer.
Manual Soaking
To soak a clothes load, start a wash in the
desired cycle. After fill is complete and wash drum
has started tumbling, turn the cycle selector
knob to OFF. When the clothes have soaked the
desired length of time, turn the cycle selector
knob to the cycle and press the start button to
restart the cycle.
DOOR Light
When the washer is started, the DOOR light will
come on after a short delay. The light will turn off
approximately 45 seconds after the cycle is
complete.
WASH Light
This light comes on during the wash part of each
cycle.
RINSE Light
This light comes on for the rinse portion of each
cycle.
FINAL SPIN Light
This light comes on while the wash load is in the
final spin of the cycle.
HEATING Light (Red Light – on select
models only)
This light comes on during the Boosted Hot
setting only. While the washer is heating, the
HEATING light will turn on.
Out of Balance Load
If at the end of the cycle, the load is dripping wet,
the washer has limited the spin speed. This is to
prevent damage to the unit if there is a severely
unbalanced load.
If this condition occurs, redistribute the load
manually and run a RINSE & SPIN cycle.
If the condition persists, consider steps
discussed in the Before Washing section.