Owner's manual

Page 8

STEP 3: Attach the tongue assembly (5) to the tank assembly (4) using two 1/2” NC x 4-1/2” hex cap bolts (1), two 1/2”

lock washers (2) and two 1/2” hex nuts (3). Tighten.

ITEM NO. DESCRIPTION QTY.

1 Beam Assembly 1

2 Pivot Pin 1

3 1/2”-3/4” R Clip Pin 1

STEP 4: Stand the beam (1) up on end. Two people may be needed for this step to ensure safety. Make sure that the

beam is stable and on a level surface. Remove the pivot pin (2) and clip pin (3) from the tank assembly. Roll

the tongue/tank assembly into position between the two tabs on the beam (1). Slide the pivot pin (2) through

the aligned holes and lock in place with the clip pin (3).

ITEM NO DESCRIPTION QTY.

 1 1/2”NCx4-1/2”Bolt  2

2 1/2” Lock Washer 2

3 1/2” NC Hex Nut 2

4 Tank Assembly 1

Tank Assembly (CA) 1

5 Tongue Assembly 1