5 TON ELECTRIC/HYDRAULIC LOG SPLITTER MODEL NO. 40100500 Owner’s Manual ASSEMBLY & OPERATING INSTRUCTIONS This safety alert symbol identifies important safety messages in this manual. Failure to follow this important safety information may result in serious injury or death. LS102-778-0810 Rev.
Table of Contents Page(s) Important Safety Information................................................................................................................. 1-6 Intended Use ......................................................................................................................... 1 Personal Protective Equipment ............................................................................................... 1 General Safety ..........................................................
WARNING: Read and thoroughly understand all instructions and safety information before assembling or operating this log splitter. Failure to do so may cause serious injury or death. Do not allow anyone to operate this log splitter who has not read this manual. As with all power equipment, a log splitter can be dangerous if assembled or used improperly. Do not operate this log splitter if you have doubts or questions concerning safe operation.
SAFETY DECALS Make sure that all safety warning decals are in good condition and readable. Always replace missing or defaced decals. Write us or call 1-800-525-8322 and they will be sent to you at no charge. LOCATION: FRONT END OF LOG SPLITTER PART NUMBER: 52061900 LOCATION: SIDE OF BEAM, WEDGE END PART NUMBER: 52036900 LOCATION: FRONT END OF LOG SPLITTER PART NUMBER: 52062000 Read the manual carefully befor assembly, operation and maintenance. Wear safety gloves. Wear safety shoes or heavy boots.
PREPARATION OF THE LOG Both ends of the log should be cut as square as possible to help prevent the log from riding out of the splitter during ER operation. Do not split logs greater than 21 in. in length. WORK AREA NEVER operate the log splitter on slippery, wet, muddy or icy ground. ONLY operate your log splitter on a level surface. Operating on a slope could cause the log splitter to roll over or logs to fall off. ALWAYS keep children away from the log splitter.
ALWAYS check for damaged parts before operation. Do not operate until it is repaired. NEVER use an extension cord longer than 25 feet. Minimum cord gage must be 16. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. NEVER stand or ride on the log splitter. Serious injury could result if the unit is tipped over or if the cutting wedge is contacted. ALWAYS keep guards in place. Do not remove. NEVER force or push the log when splitting.
REPAIR AND MAINTENANCE SAFETY NEVER operate your log splitter when it is in poor mechanical condition or in need of repair. ALWAYS unplug the power cable before performing any maintenance and repair. Periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tightened. NEVER alter your log splitter in any manner such as adding a rope or extenstion to the control lever or adding to the width or height of the wedge.
HYDRAULIC SAFETY The hydraulic system of your log splitter requires careful inspection along with the mechanical parts. Be sure to replace frayed, kinked, cracked or otherwise damaged hydraulic hose and components. NEVER check for leaks of hydraulic fluid with your hand. Fluid escaping from a small hole can be almost invisible. Escaping fluid under pressure can have sufficient force to penetrate skin causing serious personal injury or even death.
ASSEMBLY INSTRUCTIONS NOTE: This log splitter was completely assembled at the factory. Refer to the drawing and parts list should it become necessary to disassemble the unit for repair or replacement of parts. Accessories NOTE: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Hydraulic tank Wedge Ram Log cradle Electric motor Connecting box Switch Power cable and plug Wheel Control handle Front frame Towing handle Vent plug Oil dipstick 1 2.
CAUTION: NOTE: NEVER START OR RUN THE LOG SPLITTER WITHOUT OIL IN THE HYDRAULIC RESERVOIR. ALWAYS CHECK THE LEVEL OF THE HYDRAULIC RESERVOIR BEFORE OPERATION. If hydraulic oil is difficult to obtain, Dextron automatic transmission fluid can be substituted. Use only clean oil and take care to prevent dirt from entering the hydraulic reservoir. Do not mix AW32 hydrualic fluid with Dextron transmission fluid. Log splitter is shipped with AW32 hydraulic oil.
OPERATION WARNING: ALWAYS WEAR SAFETY GLASSES, SAFETY GLOVES, SAFETY SHOES AND SUITABLE WORK CLOTHING WHEN OPERATING THIS LOG SPLITTER. NEVER WEAR JEWELRY, NECKTIES OR OTHER LOOSE CLOTHING WHICH COULD GET CAUGHT IN MOVONG PARTS. DANGER: KEEP HANDS AND FEET CLEAR OF RAM AND WEDGE AT ALL TIMES. WARNING: KEEP AWAY FROM FLAMMABLE LIQUIDS AND GASES BEFORE STARTING MACHINE 1) Place the log splitter on a sturdy, level surface. Block the wheels to prevent movement of the log splitter during operation.
8) Depress the control handle so that the cylinder will drive the ram into the log. Extend the cylinder until the log splits or to the end of its stroke. If the log has not completely split after the cylinder has reached the end of its extension, retract the cylinder. 9) When the log has split, retract the ram for loading the next log. CAUTION: ALWAYS SPLIT THE LOG ALONG ITS GRAIN. IF SPLIT ACROSS THE GRAIN SOME TYPES OF WOOD MAY BURST OR FLY OUT RESULTING IN INJURY.
MAINTENANCE 1) Switch off and unplug power cable before performing any maintenance, adjustment or repair. Make sure to remove any tools and accessories from the work work area when done. 2) Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil supply will cause severe damage to the pump. 3) Wipe the unit after use with an oiled rag to prevent rust. 4) The hydraulic system is preset at the factory. Do not adjust the valve.
PARTS BREAKDOWN FOR 40100500 LOG SPLITTER REFRENCE NO. 2 3 4, 6-9 5 10 10-13 14 15-18 19-21 22 23 24 25 26 27 28 29 29-30 31 33 32,33 32-36 37-40, 111, 112 38 38, 40, 42, 44 111, 112, 113 40, 44 41-44, 113 42 45 45-47 48-51 52 53 54 55, 70-72 56-60 61-66 66 67-68 69 73-76 77-78 79-81 82-83 83 82-87 88 88-92 93-95 96 96-99 100-102 100-103 104 104-106 111 112 113 SPEECO NO.
Page 13
IMPORTANT NOTICE We, the manufacturer, reserve the right to change the product and/or specifications in this manual without notification. The manual is for information usage only and the pictures and drawings depicted herein are for reference only. WARRANTY This log splitter is guaranteed to be free from defects for one full year from the date of purchase. Do not return this product to the store for warranty issues or repair. Call 1-800-525-8322 for the location of the nearest service center.
TECHNICAL SPECIFICATIONS MAXIMUM SPLITTING FORCE* ELECTRICAL REQUIREMENT POWER OUTPUT RATED CURRENT 5 Tons 110V/60hZ 1500W 12A MOTOR SPEED 3400 RPM POWER CABLE SJTW 14AWG (2.08MM2) HYDRAULIC CAPACITY CYCLE TIME* 3.3 Quarts 16 seconds MAXIMUM LOG LENGTH 21" MAXIMUM LOG DIAMETER 9" HYDRAULIC PRESSURE 20MPa MAXIMUM CYLINDER STROKE 20-1/2" TIRE SIZE MACHINE DIMENSIONS (LXWXH) NET WEIGHT 7" 38-1/4" x 11" x 18" 105 lbs.
