User's Guide

July 2019 83
PLT-02931, Rev. A.1 Printing preferences
Lam Flipper Card Position Offset Position of the card on the flipper table. 1 = .0076 inches.
Lam Right Full Card Top Of Form Controls the card’s leading edge position relative to the hot roller. 1 = .0014
inches.
Lam Right Laminate Top Of Form Controls the right side lam patch leading edge position relative to the card.
1 = .0014 inches.
Lam Right Full Card End Of Form Position of the end a lamination. 1 = .0014 inches.
Lam Right Half Card End Of Form Position of the end of a half patch lamination. 1 = .0014 inches.
Lam Left Full Card Top Of Form Card’s leading edge position relative to the hot roller. 1 = .0014 inches.
Lam Left Laminate Top Of Form Controls the right side lam patch leading edge position relative to the card.
1 = .0014 inches.
Lam Left Full Card End Of Form Position of the end a lamination. 1 = .0014 inches.
Lam Left Half Card End Of Form Position of the end of a half patch lamination. 1 = .0014 inches.
Lam Standby Temperature Hold temperature between jobs. 1 = 1° C.
Lam Sleep Time Time in minutes before going to sleep. 1 = 1 minute.
Lam Whole Patch Speed Patch speed (tension) during lamination. 1 = 1 step/sec.
Lam IC Cutout Patch Speed IC Cutout patch (tension) speed during lamination. 1 = 1 step/sec
Lam Flatten TOF Adjusts the position of the card when the flattener roller engages the card.
1 = .0014 inches.
Lam Flatten EOF Adjusts the position of the card when the flattener roller disengages from the
card. 1 = .0014 inches.
Enable Lam Registration Pass Enable registration pass for card.
Setting Description