User's Guide

50 July 2019
Printing preferences PLT-02931, Rev. A.1
Left/Right
Lamination Type: The type of laminate affects the temperature required for lamination.
Available options are:
■ Clear Whole PolyGuard
■ Clear Whole UV Blocking PolyGuard
■ Holographic Orbit View PolyGuard
■ Holographic Whole PolyGuard
■ Clear Chip Cutout PolyGuard
■ Clear Chip Cutout UV Blocking PolyGuard
■ Holographic Chip Cutout PolyGuard
Lamination Position: Click the arrows to adjust the horizontal position of the laminate. The
default is 0. The adjustment arrows point in the direction the patch moves on the card. The
maximum horizontal value is 100 pixels (10 pixels=0.03 [0.8mm])
Lamination Temp offset: Available values are +/- 20.
Flatten Card
Enable: Select this option to enable the flattener.
Dwell Time (seconds per inch): Sets the Dwell Time for the flattening process.
■ Lower limit = 1 second per inch
■ Upper limit = 3 seconds per inch
Print Mode If Flip Card Before Print is selected, the reverse side of the card is printed first.
Note: This option is available only for dual-sided card printing and is grayed out if a dual-sided
module is not detected.
Device Settings
Menu option Description