Instructions / Assembly

Double Ended
Left Stack - Odd panels Right Stack - Odd panels
Left Stack - Even panels Right Stack - Even panels
View
Front View: Lead Panel to Viewer
1 2 3
1 2 3 4
Mounting Panel to viewer
Mounting Panel away from viewer
#8 x 1½ Pan or
Truss Head Screw
Pin Hinge Hardware
Body Panel
Structural Material
At least ¾”
Non-structural
Material
2
Install140-120906
2 track inStallation
Dry t the track in the opening. The correct length will just t into the opening. If
needed, trim the track with a hacksaw. Try to keep the metal lings from mixing
with grease inside the track.
Contact Woodfold if the track is too short by more than ½” .
Thread the track onto wheels; lineup the wheels properly in the track grooves. Be
careful not to insert the wheels sideways. You won’t like the result.
Conrm the proper orientation of the door. See the illustrations of Left or Right
Stack or Double Ended doors above. Position the track to ensure: a) it can be se-
curely attached to the header and b) the Mounting Panel can be securely attached to the wall or doorjamb.
Stack the door to one end of the track (either side of the opening is OK) and attach the other end of the track to
the header. Use 1½” #8 pan head screws through the rst 2 holes at the end of the track. Seat the head of the
screw rmly against the track.
#8- 1½” Pan Head
Track Screw
Caution! Firmly attach the track to the structural header!
Sheet rock and many decorative materials do not provide adequate support
Check it out! Move the door back and forth along the track looking for
smooth operation. Most frequent problems include screw heads sticking out,
wheels sideways or debris in the track.
Power Screw Drivers: Check the length of your #2 Phillips Bit. It needs to extend at least 1¼” past the chuck. Any
shorter and the chuck may tear up the track or the screw won’t seat. It falls into the frustrating category when you
have to ask Woodfold for a new track.
Door Stacking: Double Ended (DE), Left Handed (LH),
Right Handed (RH)
For the purpose of these instructions, doors come in three basic
congurations: Double Ended (DE), Left Hand Stacked (LH) and
Right Hand Stacked (RH). DE doors have Lead Panels (Panel
with Swept Wing Handle) at each end of the Panel set. LH and
RH doors have a Lead Panel on one end and a Mounting Panel
on the other end. Left or Right handing is determined when the
door is viewed from the front.
Even and Odd Door Panels
The factory puts in enough door panels to ll the opening. That
seems obvious, but it means some doors have an even number
of panels and others an odd number. The consequence is that
the mounting panel on your door may point in the other direc-
tion than those shown in illustrations.
If the screws didn’t go into a solid part of the header (soft stu like sheet rock or acoustical
tile doesn’t count) at least ¾”, now would be a good time to go to the hardware store and get
longer #8 Pan Head or Truss Head screws.
Transfer the door to the attached end of the track. Finish attaching the track with 1½” #8 Pan
Head screws.