Instructions / Assembly

Echo/Fusion Installation Instructions
DOUBLE DOOR INSTALLATION
1. Measure the Door Opening
Divide the width of the opening by two. Cut each top track to this
measurement so that when installed, the tracks butt against one another
in the center of the door opening.
2. Install the Top Track
On a center line drawn across the top of the door opening, install either
track and install all screws in this track. You will install the remaining track
later.
3. Attach the Handles
T
ap the two handle attachment pins into one handle, then fit the pins
through the door panel holes. Press the other handle onto the pins. If
necessary, you may back one handle with a solid object and tap the
other handle alternately over each pin area until the handles are seated.
Repeat with the handle for the other door.
4. Hang the Doors onto the Track
Slide both doors onto the installed track with the lead edges facing each
other.
5. Install Remaining Top Track
Install the second track. Slide one of the doors onto this track. Set a
track screw at the track center joint and leave the screw projecting down
½” to prevent the glides from passing the joint.
6. Install the Anchor Channel Clips and
Secure the Anchor Panel
Use the closure channel to measure and align
the channel clips. Align the channel on the
non-opening side of the door jamb. Make
sure the top of the channel is straight
up and down.
Mark each of the five closure channel screw
holes and remove the closure channel. Make
pilot holes (with a nail or a 3/32” drill bit) and
install the channel clips loosely, using five of
the 1” roundhead screws. Align the clips
vertically and fully tighten the screws. Press
the door anchor panel onto them until it
snaps into place.
Repeat on the other door jamb.
7.
Install the Closure Channel
Align the closure channel on the lead edge of
one of the doors so that it is flush with the
top and bottom of the door. Mark the pre-
drilled holes in the Closure channel. Set the
closure channel aside and drill pilot holes
where you marked the lead edge. Secure the
closure channel to the lead edge with the 1”
flathead screws.
8. Attach the Locking Clip
Align the locking clip with the pre-dilled hole
located on the lead edge of the other door
(between the door handles). Secure the
locking clip with a 1” flathead screw.
Anchor
Channel
Clip
Locking
Clip
Handle
Top Track
Anchor
Panel
Lead
Edge
Top Track
Anchor
Panel
Anchor
Channel
Clip
Closure
Channel
Top Glide
Top Glide