Instructions / Assembly
Echo/Fusion
Installation
Instructions
For quick and easy installation of your folding door
, read
these instructions thoroughly.
The Tools You Will Need
You will need a Drill, Phillips screwdriver bit, 3/32” drill bit
for pilot holes, small Phillips head screwdriver, tape
measure, pencil, fine tooth hacksaw (for cutting the top
track), safety glasses and fine sandpaper (can be used to
smooth edges after cutting top track) and a level.
Make sure all of the following Parts are
included before you begin:
Door Parts Location
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
Measure the height and width of your nished opening. This
door ts openings that are 24” to 36” wide and 80” high.
If the height of your
door opening is
approximately 80”,
you will not need to
alter the height of the
door. If the opening
is less than 80” high,
the door may be
shortened by sawing
the excess from the
bottom of the door panels.
Trimming the Door Height:
Stack the door panels together and secure with masking
tape. Remove bottom hinge screws. Cut excess o with a
hacksaw or le. Replace bottom hinge screws and
remove tape.
2. Install the Top Track
Cut the top track 1/8”
shorter than the width
of the nished opening.
Position the top track
in the top of the door
opening so that it is
straight and centered.
After making a pi-
lot-hole (with a 3/32”
drill bit), insert a 1”
track screw through
the pre-drilled hole
nearest the center of the track. Do not fully tighten. (Tape
may be used to hold the track in place while you mark and
drill.)
3. Attach the Handle
Tap the two handle
attachment pins into
one handle, then t the
pins through the door
panel holes. Press the
other handle onto the
pins.
If necessary, you may
back one handle with a
solid object and tap the
other handle alternately
over each pin area until
the handles are seated.
2 Ea.
Handles
1 Ea.
36” Top Track
1 Ea.
Closure
Channel
5 Ea.
Anchor
Channel
Clips
1 Ea.
Locking Clip
6 Ea. (1”)
Anchor Channel Screws
12 Ea. (1”)
Flat Head
Screws
1 Ea.
Locking Clip
Screws
Top Track
Closure
Channel
Handle
Top Glide
Anchor
Panel
Lead
Edge
2 Ea.
Handle Pins
1 Ea.
Spare
Top Glide
1 Ea.
Spare Top
Glide Screw
Anchor
Channel
Clips
Locking
Clip