Instructions / Assembly

Royale/Ellington Installation
Instructions
DOUBLE DOOR INSTALLATION
1. Measure the Door Opening
Divide the width of the opening by two. Cut each top track to this
measurement so that when installed, the tracks butt against one another in
the center of the door opening.
2. Install the Top Track
On a center line drawn across the top of the door opening, install either track
and install all screws in this track. You will install the remaining track later.
3. Attach the Handles
T
ap the two handle attachment pins into one handle, then fit the pins through
the door panel holes. Press the other handle onto the pins. If necessary, you
may back one handle with a solid object and tap the other handle alternately
over each pin area until the handles are seated. Repeat with the handle for
the other door.
4. Hang the Doors onto the Track
Slide both doors onto the installed track with the lead edges facing each other.
5. Install Remaining Top Track
Install the second track. Slide one of the doors onto this track. Set a track
screw at the track center joint and leave the screw projecting down ½” to
prevent the glides from passing the joint.
6.
Install the Anchor Channels
Place the anchor channel on one side of
the door jamb. Use a level to make sure
the channel is plumb. Mark the pre-drilled
holes in the channel. Remove the channel
and drill pilot holes where you marked the
jamb. Secure the anchor channel to the
jamb using the 1” flathead screws
provided. Snap the anchor panel into the
channel. Repeat these steps on the other
side of the door jamb.
7. Install the Closure Channel
Align the closure channel on the lead edge
of one of the doors so that it is flush with
the top and bottom of the door. Mark the
pre-drilled holes in the Closure channel.
Set the closure channel aside and drill
pilot holes where you marked the lead
edge. Secure the closure channel to the
lead edge with the 1” flathead screws.
8. Attach the Locking Clip
Align the locking clip with the pre-dilled
hole located on the lead edge of the other
door (between the door handles). Secure
the locking clip with a 1” flathead screw.
Anchor
Channel
Locking
Clip
Handles
Top Track
Anchor
Panel
Lead
Edge
Top Track
Anchor
Panel
Anchor
Channel
Closure
Channel
Top Glide
Top Glide