Instructions / Assembly

DOUBLE DOOR INSTALLATION
1. Measure the Door Opening
Divide the width of the opening by two. Cut each top track
to this measurement so that when installed, the tracks butt
against one another in the center of the door opening.
2. Install the Top Track
On a center line drawn across the top of the door opening,
install either track and install all screws in this track. You will
install the remaining track later.
3. Attach the handles
Take the female handle and separate it into two pieces. Take
one of the handle screws and put it through the back of the
inner piece. Insert the screw through the top pre-drilled
handle hole on the lead edge. Take the male handle and
line it up with the screw shaft on the other side of the door.
Tighten with screwdriver until it catches. Do not tighten fully.
Repeat these steps for the bottom of the handle then fully
tighten the 2 screws. Snap the cover back onto the female
handle. Repeat with the other handle.
4. Hang the Doors onto the Track
Slide both doors onto the installed track with the lead edges
facing each other.
Metro/Century Installation Instructions
5. Install Remaining Top Track
Install the second track. Slide one of the doors onto this
track. Set a track screw at the track center joint and leave
the screw projecting down ½” to prevent the glides from
passing the joint.
6. Install the Anchor Channels
Place the anchor channel on one side of the door jamb.
Use a level to make sure the channel is plumb. Mark the
pre-drilled holes in the channel. Remove the channel and
drill pilot holes where you marked the jamb. Secure the
anchor channel to the jamb using the 1” athead screws
provided. Snap the anchor panel into the channel. Repeat
these steps on the other side of the door jamb.
7. Install the Closure Channel
Align the closure channel on the lead edge of one of the
doors so that it is ush with the top and bottom of the door.
Mark the pre-drilled holes in the Closure channel. Set the
closure channel aside and drill pilot holes where you marked
the lead edge. Secure the closure channel to the lead edge
with the 1” athead screws.
8. Attach the Locking Clip
Align the locking clip with the pre-dilled hole located on the
lead edge of the other door (between the door handles).
Secure the locking clip with a 1” athead screw.
Anchor
Channel
Locking
Clip
Handle
Top Track
Anchor
Panel
Lead
Edge
Top Track
Anchor
Panel
Anchor
Channel
Closure
Channel
Top Glide
Top Glide