Installation Guide

DOUBLE DOOR INSTALLATION
1. Measure the Door Opening
Divide the width of the opening by two. Cut each top track
to this measurement so that when installed, the tracks butt
against one another in the center of the door opening.
2. Install the Top Track
On a center line drawn across the top of the door opening,
install either track and install all screws in this track. You will
install the remaining track later.
3. Attach the Handles
Tap the two handle attachment pins into one handle, then t
the pins through the door panel holes. Press the other handle
onto the pins. If necessary, you may back one handle with a
solid object and tap the other handle alternately over each pin
area until the handles are seated. Repeat with the handle for
the other door.
4. Hang the Doors onto the Track
Slide both doors onto the installed track with the lead edges
facing each other.
5. Install Remaining Top Track
Install the second track. Slide one of the doors onto this
track. Set a track screw at the track center joint and leave
the screw projecting down ½” to prevent the glides from
passing the joint.
Echo Installation Instructions
6. Install the Anchor Channel Clips and
Secure the Anchor Panel
Use the closure channel to measure and align the channel
clips. Align the channel on the non-opening side of the door
jamb. Make sure the top of the channel is straight
up and down.
Mark each of the ve closure channel screw holes and
remove the closure channel. Make pilot holes (with a nail or a
3/32” drill bit) and install the channel clips loosely, using ve
of the 1” roundhead screws. Align the clips vertically and
fully tighten the screws. Press the door anchor panel onto
them until it snaps into place.
Repeat on the other door jamb.
7. Install the Closure Channel
Align the closure channel on the lead edge of one of the
doors so that it is ush with the top and bottom of the door.
Mark the pre-drilled holes in the Closure channel. Set the
closure channel aside and drill pilot holes where you marked
the lead edge. Secure the closure channel to the lead edge
with the 1” athead screws.
8. Attach the Locking Clip
Align the locking clip with the pre-dilled hole located on the
lead edge of the other door (between the door handles).
Secure the locking clip with a 1” athead screw.
Anchor
Channel
Clip
Locking
Clip
Handle
Top Track
Anchor
Panel
Lead
Edge
Top Track
Anchor
Panel
Anchor
Channel
Clip
Closure
Channel
Top Glide
Top Glide