Installation Guide

Echo Installation Instructions
4. Hang Door onto Track
Swing one end of the top track outward. Decide if the door
will open from the left or the right, then slide all of the top
glides onto the track. Stack the panels together near the
center screw. Swing the track back to its original position.
5. Secure the Top Track
Drill pilot holes through the remaining pre-drilled holes in the
top track and secure the track with the Track screws
provided. Set all screws as straight and tight as possible to
ensure the smooth operation of the door.
6. Install the Anchor Channel Clips
and Secure the Anchor Panel
Use the closure channel to measure and
align the channel clips. Align the
channel on the non-opening side of the
door jamb. Make sure the top of the
channel is straight up and down.
Mark each of the ve closure channel
screw holes and remove the closure
channel. Make pilot holes (with a nail
or a 3/32” drill bit) and
install the channel clips
loosely, using ve of the
1” round- head screws.
Align the clips vertically
and fully tighten screws.
Press the door anchor
panel onto them until it
snaps into place.
7. Install the Closure Channel
Place the closure channel on the
opening side of the door jamb. Use
a level to make sure the channel is
plumb. Mark the pre-drilled holes in
the channel. Remove the channel and
drill pilot holes where you marked the
jamb. Secure the closure channel to
the jamb using the 1” athead screws
provided.
8. Attach Locking Clip
Align the locking clip with the
pre-dilled hole located on the
lead edge (between the door
handles). Secure the locking
clip with a 1” athead screw.