Installation Guide

DOUBLE DOOR INSTALLATION
1. Measure the Door Opening
Divide the width of the opening by two. Cut each top track
to this measurement so that when installed, the tracks butt
against one another in the center of the door opening.
2. Install the Top Track
On a center line drawn across the top of the door opening,
install either track and install all screws in this track. You will
install the remaining track later.
3. Attach the Door Knob
Take the male handle and remove the screw. Put the screw
through the inside of the female handle and insert the screw
through the pre-drilled handle hole on the lead edge. Take the
male handle and line it up with the screw shaft on the other
side of the door. Tighten with screwdriver until secure.
Snap the cover onto the female handle.
4. Hang the Doors onto the Track
Slide both doors onto the installed track with the lead edges
facing each other.
Capri/Devonshire Installation Instructions
5. Install Remaining Top Track
Install the second track. Slide one of the doors onto this
track. Set a track screw at the track center joint and leave
the screw projecting down ½” to prevent the glides from
passing the joint.
6. Install the Anchor Channels
Place the anchor channel on one side of the door jamb.
Use a level to make sure the channel is plumb. Mark the
pre-drilled holes in the channel. Remove the channel and drill
pilot holes where you marked the jamb. Secure the anchor
channel to the jamb using the 1” athead screws provided.
Snap the anchor panel into the channel. Repeat these steps
on the other side of the door jamb.
7. Install the Closure Channel
Align the closure channel on the lead edge of one of the
doors so that it is ush with the top and bottom of the door.
Mark the pre-drilled holes in the Closure channel. Set the
closure channel aside and drill pilot holes where you marked
the lead edge. Secure the closure channel to the lead edge
with the 1” athead screws.
8. Attach the Door Latch
Close the door until almost fully closed and mark the
location on the closure channel where the latch hole on the
lead edge would hit the channel. Place the top of the door
latch piece at this location on the closure channel and secure
the latch with a 1” athead screw. Once the door is in the
closed position and the door is latched, the key can be used
to lock the door.
Anchor
Channel
Door
Latch
Door
Knob
Top Track
Anchor
Panel
Lead
Edge
Top Track
Anchor
Panel
Anchor
Channel
Closure
Channel
Top Glide
Top Glide