Installation Guide

Capri/Devonshire Installation Instructions
For quick and easy installation of your folding door, read
these instructions thoroughly.
The Tools You Will Need
You will need a Drill, Phillips screwdriver bit, 3/32” drill bit for
pilot holes, small Phillips head screwdriver, tape measure,
pencil, ne tooth hacksaw (for cutting the top track), safety
glasses and ne sandpaper (can be used to smooth edges
after cutting top track) and a level.
Make sure all of the following Parts are
included before you begin:
Door Parts Location
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
Measure the height and width of your nished opening. This
door ts openings that are 24” to 36” wide and 80” high.
The door height cannot be trimmed or altered.
2. Install the Top Track
Cut the top track 1/8” shorter than the width of the nished
opening. Position the top track in the top of the door
opening so that it is straight and centered. After making a
pilot-hole (with a 3/32” drill bit), insert a 1” track screw
through the pre-drilled hole nearest the center of the track.
Do not fully tighten. (Tape may be used to hold the track in
place while you mark and drill.)
3. Attach the Door Knob
Take the male handle and remove the screw. Put the screw
through the inside of the female handle and insert the screw
through the pre-drilled handle hole on the lead edge. Take the
male handle and line it up with the screw shaft on the other
side of the door. Tighten with screwdriver until secure.
Snap the cover onto the female handle.
2 Piece
Door Knob
1 Ea. 36” Top
Track
1 Ea.
Closure
Channel
1 Ea.
Anchor Channel
6 Ea. (1”)
Track Screws
14 Ea.
(1”) Flat Head
Screws
1 Ea.
Door Latch
1 Ea.
Door Knob Screw
Anchor
Channel
Top Track
Closure
Channel
Door
Latch
Door Knob
1 Door
Knob
Cover
Top Glide
Anchor
Panel
Lead
Edge
2 Door Key
Door Knob
Cover