Installation Guide

For quick and easy installation of your folding door, read
these instructions thoroughly. A few minutes of prior
planning will make the job easier and will ensure years of
trouble-free use.
The Tools You Will Need
You will need a small #1 Phillips screwdriver, a athead
screwdriver, a tape measure, a small nail, and a 3/32” drill bit
for pilot holes , a hacksaw or ne tooth saw (saw needed to
trim top track for the appropriate width or to trim height of
panels if necessary). Masking tape (to secure doors if
trimming is necessary.) Safety glasses. Fine sandpaper (used
to smooth edges after trimming).
SINGLE DOOR INSTALLATION
1. Measure the Door Opening
If the height of your door opening is
approximately 80”, you will not need
to alter the door itself. If the opening
is less than 80” high, the door may be
shortened by sawing o excess from
the bottom of the door panels.
To Trim Height and Top Track
Stack the door panels together and
secure with masking tape. Remove
bottom hinge screws. Cut excess with
a hacksaw or ne tooth saw. Cut the
top track 1/8”shorter than the width of
the opening.
Reinsert hinge screws.
2. Install the Top Track
Position the top track on the top of the door opening so
that it is straight and
centered.
After making a pilot hole
(with a nail or a 3/32” drill
bit), drive a 1” track screw
through the screw hole
nearest the center of the
track. Do not tighten fully at
this point to allow the track to
swing out for Step 4. (Tape
may be used to hold the track in place while you mark
and drill.)
3. Install the Handles
Tap the two handle
attachment pins into one
handle, then t the pins
through the door panel
holes. Press the other
handle onto the pins.
If necessary, you may
back one handle with a
solid object and tap the
other handle alternately
over each pin area until
the handles are seated.
Do not strike the middle of either handle.
4. Install the Door Panels
Swing one end of the
top track out of the
door opening to accept
the top glides.
Decide if you want the
door to open from the
left or the right, then
slide all top glides onto
the track.
Stack the panels to-
gether near the center screw.
INSTALLATION INSTRUCTIONS
Make Sure All The Following Parts Are
Included With Your Folding Door:
Top Track
Guía superior
Top Glides
Patines superiores
Channel Clips
Ganchos para el canal
Anchor Panel
Panel de fijación
Locking Clip
Gancho de Traba
Closure Channel
Canal de cierre
Lead Edge
Borde delantero
Handle
Manija
Door Parts Location
Elite 80”
80” Door
15 Flathead Screws (1”)
5- Channel Clips
5- Closure Channel
1- Locking Clip
4- Extra Screws