User's Manual
SM-ETS Confidentia Spectrum Tracking Systems, LLC 2545
Tarpley Road
Carrollton, Texas 75006
SM-ETS, lms, 2013-07-10Page3of4
Device Repacking, Standard Firmware
1. While maintaining the device in proximity with the Mag-Plate, remove it from its
‘host enclosure’. This isn’t critical, but it minimizes the possibility of inadvertent
activation.
2. While maintaining the device in proximity with the Mag-Plate, disconnect the battery
leads.
Device Preparation, VHF Test Firmware
1. Remove the device from its ‘host enclosure’, and place device onto the Mag-Plate.
2. While maintaining the device on the Mag-Plate, connect the battery leads.
3. Observe the device. The Green LED should immediately begin flashing at a 1 Hz
rate. The duty-cycle of the flashes is 12% (mostly off) while the device remains on
the Mag-Plate, and is 88% (mostly on) while the device is separated from the Mag-
Plate. VHF transmission is OFF while the device remains on the Mag-Plate, and is
ON while the device is separated from the Mag-Plate.
4. Insert the device into its ‘host enclosure’ while maintaining device in close proximity
to the Mag-Plate. This isn’t critical, but it minimizes the possibility of inadvertent
activation.