User guide

Micro800™ 4 Ch Universal Analog Input Module 8
Publication 0100189-02 Rev. A
Table 1 (Configuration Assembly)
Bits
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
MSB LSB
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
Ch0
Config.
2x Bytes
Channel
Enable
Enable
Disable
0
1
Filter Frequency 17 Hz
4 Hz
60 Hz
240 Hz
470 Hz
0
0
0
0
1
0
0
1
1
0
0
1
0
1
0
Input Type 4-20 mA 0 0 0 0
0-20 mA 0 0 0 1
+/-10 V 0010
0-10 V 0 0 1 1
0-5 V 0 1 0 0
+/-100 mV 0 1 0 1
+/-50 mV 0110
Type J TC 0111
Type K TC 1000
Type T TC 1 0 0 1
Type E TC 1010
100 Pt 385 1 0 1 1
1000 Pt 385 1 1 0 0
100 Pt 3916 1 1 0 1
1000 Pt 3916 1 1 1 0
0-3000 Ohms 1 1 1 1
Undefined Bits x x
Data Format
1
Engr. X1
Engr. X10
0
0
0
1
Temp. Units Degrees C
Degrees F
0
1
2/3/4 Wire RTD 2 Wire
3 wire with lead
4 wire
0
0
1
0
1
0
CJC enable Enable
Disable
0
1
Ch1
Config.
2x Bytes
Data structure the same as channel 0 above
Ch2
Config.
2x Bytes
Data structure the same as channel 0 above
Ch3
Config.
2x Bytes
Data structure the same as channel 0 above
1
See Table 2 (Data Format)
Micro800™ 4 Ch Universal Analog Input Module 17
Publication 0100189-02 Rev. A
Environmental Tests Industry Standards Test Level Limits
Oscillatory Waves
IEC 61000-4-18
Rockwell Document QTP#X0327
Not Tested
Safety Tests Industry Standards Test Level Limits
As required UL 508 Industrial Control Equipment Seventeenth Edition Dated January 28
1999, with revisions through July 11, 2005 (ANSI/UL 508-2005) (NRAQ,
NRAQ7)
CUL CSA C22.2 No. 142 -M1987 Process Control Equipment May 1987
ULH ANSI/ISA–12.12.01–2007 Nonincendive Electrical Equipment for Use in
Class I, Division 2 Hazardous (Classified) Locations
CULH CSA C22.2 No. 213-M1987 - Non-incendive Electrical Equipment for use
in Class I Division 2 Hazardous Locations - March 1987
As required
As required Ex IEC 60079-15:2005 -Electrical apparatus for explosive gas atmospheres –
Part 15: Construction, test and marking of type of protection "n" electrical
apparatus - Edition 3
IEC 60079-:2006
As required
As required CE LVD IEC 1131-2 Programmable Controllers Part 2: Equipment
Requirements and Tests; Second Edition 2003-02, Section 11-14
As required