Manual
Table Of Contents
- Important Notes
- Notice
- Limited Warranty
- Preface
- Chapter 1 Module Overview
- Chapter 2 Installation and Wiring
- Chapter 3 Configuring the Module using Software
- Section 3.1 Configuring the System
- Section 3.2 Setting Up Tags
- Section 3.3 Editing XML Tag Information
- Section 3.4 Generating Structured Text
- Section 3.5 Using the CCW Structured Text Example
- Section 3.6 Viewing Version Information
- Section 3.7 Viewing Log Information
- Section 3.8 Upgrading the Software
- Section 3.9 Saving Changes
- Section 3.10 Reloading System Configuration
- Chapter 4 Implementing the BACnet Protocol
Chapter 3: Configuring the Module 3-3
User’s Manual Pub. 0300274-01 Rev. A.0
The following dialog appears:
5. Type the password spectrum into the Password field and click Submit.
The BACnet configuration dialog appears.
The examples shown below use IP addresses that have been reconfigured
to work on a different network from the default IP address :
6. View or modify the following options:
System Configuration. Use to set up password, date and time,
device, and LAN settings.
Tag Setup. Use to set up tag mapping between your Micro800
controller and the BACnet Communications module.