Manual
Table Of Contents
- Important Notes
- Notice
- Limited Warranty
- Preface
- Chapter 1 Module Overview
- Chapter 2 Installation and Wiring
- Chapter 3 Configuring the Module using Software
- Section 3.1 Configuring the System
- Section 3.2 Setting Up Tags
- Section 3.3 Editing XML Tag Information
- Section 3.4 Generating Structured Text
- Section 3.5 Using the CCW Structured Text Example
- Section 3.6 Viewing Version Information
- Section 3.7 Viewing Log Information
- Section 3.8 Upgrading the Software
- Section 3.9 Saving Changes
- Section 3.10 Reloading System Configuration
- Chapter 4 Implementing the BACnet Protocol
3-2 Chapter 3: Configuring the Module
User’s Manual Pub. 0300274-01 Rev. A.0
To access the software on your module:
1. Access your PC local area connection properties dialog as shown below:
Start:Control Panel:Network and Sharing Center:Change Adapter
Settings:Local Area Connection Settings:Properties.
2. From the Local Area Connection n Properties dialog, select the Internet
Protocol Version 4 (TCP/IPv4) option:
3. Change the settings to the equivalent settings for your personal computer
as shown next:
4. Open a web browser and type in the IP default address of your BACnet
module, which is 169.254.3.3.