Manual
Table Of Contents
- Important Notes
- Notice
- Limited Warranty
- Preface
- Chapter 1 Module Overview
- Chapter 2 Installation and Wiring
- Chapter 3 Configuring the Module using Software
- Section 3.1 Configuring the System
- Section 3.2 Setting Up Tags
- Section 3.3 Editing XML Tag Information
- Section 3.4 Generating Structured Text
- Section 3.5 Using the CCW Structured Text Example
- Section 3.6 Viewing Version Information
- Section 3.7 Viewing Log Information
- Section 3.8 Upgrading the Software
- Section 3.9 Saving Changes
- Section 3.10 Reloading System Configuration
- Chapter 4 Implementing the BACnet Protocol
2-2 Chapter 2: Installation and Wiring
User’s Manual Pub. 0300274-01 Rev. A.0
1. Position the plug-in module with the terminal block facing the front of
the controller as shown. The 2080sc-BACnet module has a different
front panel setup, but the installation in the controller is the same:
2. Snap the module into the module bay.
3. Using a screwdriver, tighten the supplied, self-tapping screw to torque
specifications.
4. Wire the module using the 6-pin connector as shown:
OR
Connect an RJ-45 Ethernet cable and connector between a personal
computer and the connector on the front of the module.
Set up the tag mapping using the software described in Chapter 3.