User Manual
Chapter 2: Installation and Wiring 2-7
User'sManualPub.0300231‐01Rev.A
4) Repeat the above steps to install the next terminal base.
2.4.2 Panel/Wall Mounting
Installation on a wall or panel consists of:
• Laying out the drilling points on the wall or panel
• Drilling the pilot holes for the mounting screws
• Mounting the adapter mounting plate
• Installing the terminal base units and securing them to the wall or panel
If you are installing your module into a terminal base unit that is already installed,
proceed to “Mounting the IF8IU Module on the Terminal Base Unit” on page 2-9.
Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.