Owner's manual

Chapter 5: Diagnostics and Troubleshooting 5-5
User’s Manual Pub. 0300244-01 Rev. A
If you set the fields in the configuration file to invalid or unsupported values, the module
generates a critical error.
Table 5-3 Extended Error Codes on page 5-5 lists the possible module-specific
configuration error codes defined for the modules.
Section 5.7
Error Codes
The table below explains the extended error code.
Table 5-3 (Extended Error Codes)
Error Type
Hex
Equivalent
Module
Error
Code
(Binary)
Extended Error
Information Code
(Binary)
Error Description
No Error
X000 000 0 0000 0000 No Errors
General
Common
Hardware
Error
X200 001 0 0000 0000 General Hardware error; no additional information
X201 001 0 0000 0001 Power-up reset state
Hardware
Specific
Error
X300 001 1 0000 0000 General Hardware Error (ASIC)
X301 001 1 0000 0001 H/W ROM Error (Calibration Error)
X30B 001 1 0000 1011 Channel 0 ADC Error
X30C 001 1 0000 1100 Channel 1 ADC Error
X30D 001 1 0000 1101 Channel 2 ADC Error
X30E 001 1 0000 1110 Channel 3 ADC Error
X30F 001 1 0000 1111 Channel 4 ADC Error
X310 001 1 0001 0000 Channel 5 ADC Error
Module
Specific
Configuration
Error
X400 010 0 0000 0000 General Config Error: no additional information
X401 010 0 0000 0001 invalid input type selected ch0
X402 010 0 0000 0010 invalid input type selected ch1
X403 010 0 0000 0011 invalid input type selected ch2
X404 010 0 0000 0100 invalid input type selected ch3
X405 010 0 0000 0101 invalid input type selected ch4
X406 010 0 0000 0110 invalid input type selected ch5
X407 010 0 0000 0111 invalid input filter selected ch0
X408 010 0 0000 1000 invalid input filter selected ch1
X409 010 0 0000 1001 invalid input filter selected ch2
X40A 010 0 0000 1010 invalid input filter selected ch3
X40B 010 0 0000 1011 invalid input filter selected ch4
X40C 010 0 0000 1100 invalid input filter selected ch5
X40D 010 0 0000 1101 Invalid input format selected ch0
X40E 010 0 0000 1110 Invalid input format selected ch1
X40F 010 0 0000 1111 Invalid input format selected ch2
X410 010 0 0001 0000 Invalid input format selected ch3
X411 010 0 0001 0001 Invalid input format selected ch4
X412 010 0 0001 0010 Invalid input format selected ch5
X413 010 0 0001 0011 An unused bit has been set for ch0 (C:e.0)